Getting Started

gs_step11

PLUG IN YOUR 3DOODLER

…and select your temperature (HI or LO). While we do have designated heat settings for each plastic, feel free to play around with the heat settings, for example using PLA on the HIGH (“HI”) temperature if you want much quicker flow.
gs_step11

INSERT YOUR STRAND

When putting a new strand into the 3Doodler, don’t be afraid to push the strand firmly down the pen to ensure it engages with the gears and gets gripped properly.
gs_step11

READY SET DOODLE

It may take 30-90 seconds for your plastic to extrude.
Enjoy drawing in 3D and send us a picture of your artwork at 3doodler@freedee.hu!

Check out these getting started videos!

SNIP THOSE ENDS!

After removing a strand/filament from the 3Doodler, cut and remove any partially
melted material at the end of your strand before re-feeding it into the 3Doodler. This
will reduce blockages or clogging issues.

#WhatWillYouCreate?

To find great ideas for what you can create, as well as tips, tricks & free downloadable stencils, please visit the American community website at: www.the3Doodler.com/Community